ACC Utilities Reference Guide

ZMNTR - ZCOM Runtime Monitor
Summary of Commands
Chapter 376
Summary of Commands
The commands available through ZMNTR, in alphabetic order, are as
follows. Specific help for a particular command is obtained by entering
“??” followed by the command for which help is required. For
information on how the commands can be used for X.25, enter “?? X25”.
Command Function
?? Display help list of commands
! Execute a shell command
DC Display configuration
EX Exit program
FL Flush read from terminals
LB Perform loopback test on port
LL Set new list device
MX Display mux configuration
PT Display terminals on a port
RC Reset RX TX and error counters
R Repeat Enable/Disable
RE Reissue read to terminals
SD Shutdown terminals
SET Set or display ZMNTR settings
SU Startup terminals
TM Set time-out for auto-repeat display
TO Skip to top of form
TR Transfer to a command file
TT Display terminal table
/E Exit from ZMNTR
For the following commands, if no range of terminals is entered, then the
last range entered for any of these commands is reused:
TT, DC, RC