ACC Utilities Reference Guide

ZMNTR - ZCOM Runtime Monitor
Commands
Chapter 380
EN - Enable terminals (and DI, AC, DE)
Format: EN,mm,nn or ’DI’, ’AC’, ’DE’
These commands control the state of the terminals ranging from mm to
nn inclusive. If nn is omitted then only mm is affected.
DI- Disables the terminals.
EN- Enables the terminals.
DE- Deactivates the terminals.
AC- Activates the terminals.
Notes:-
These commands can use the X.25 modifiers L, V, and O.
A DI command will abort any untransmitted data destined for terminals
in the range.
Some terminal types go into the “Deactivated” state during the time an
application program is processing a received message. If an AC command
is issued during this time the terminal can generate another message
which may cause a sequencing problem in the application program.
Normally an AC command will not be necessary unless it has been
preceded by a DE command or if there is a problem with the application
program and it fails to automatically reactivate the terminal.
LB - Loopback Test on Port
Format: LB,mm,pp,[options]
This command runs a loopback test on the port specified by card mm port
pp.
Options:
i Do internal loopback tests within the ACC interface
card on this port.
e Do external loopback tests. These tests require a
loopback connector to be connected to the breakout
panel on the specified port.