ACC Utilities Reference Guide

ZMNTR - ZCOM Runtime Monitor
Commands
Chapter 382
The following is an example of a PORTTEST Term entry for port 3 of
ACC card 1:
TERM 500 1:3 PORTTEST 0000h 0000h 99,0,0,0,0 ”For Loopback Testing”
For E1/T1 ACC cards there is no special configuration required to run
the port test. Also there is no need to select a signalling type
(ie. option “2”). The loopback test is performed using all available
timeslots that use the E1 standard.
The various combinations of options perform tests as follows:
The example below shows the loopback performed on card 1 port 0. In
this example the port is not connected to a loopback hood. The first test
performs checks on the ACC card only (options i2) - in this case since the
card is good all tests pass. In the second case the external tests are
attempted as well as the internal ones (options ie2), but because the
loopback hood is not connected the external tests fail.
ZMNTR> lb 1 0 i2
Loopback test on Mux 01 port 0, zlu 0710
Loopback protocol functionality .. OK
RS232 RTS/CTS internal loopback .. OK
RS232 DTR/DCD internal loopback .. OK
ISCC data loopback test .......... OK
RS232 internal data loopback ..... OK
lb
options
PORTTEST
downloaded
ISCC
Loopback
Internal
Loopback
External
Loopback
none XXX
i XX
e X
ie XX
2 X
i2 XXX
e2 XX
ie2 XXXX