ACC Utilities Reference Guide

ZMNTR - ZCOM Runtime Monitor
Commands
Chapter 3 83
ZMNTR> lb 1 0 ie2
Loopback test on Mux 01 port 0, zlu 0710
Loopback protocol functionality .. OK
RS232 RTS/CTS internal loopback .. OK
RS232 RTS/CTS external loopback .. Test failed (RTS/CTS)
RS232 DTR/DCD internal loopback .. OK
RS232 DTR/DCD external loopback .. Test failed (DTR/DCD)
RS232 DTR/DSR external loopback .. Test failed (CTS/DSR/DCD)
ISCC data loopback test .......... OK
RS232 internal data loopback ..... OK
RS232 external data loopback ..... Data test timed out
LL - Set New List File
Format: LL,[filename]
The command sets the name of the file. If filename is omitted, the listing
is redirected to standard error (fd=2 which is usually the terminal).
Although ZMNTR commands are not case sensitive (that is, upper and
lower case are treated the same), the filename parameter in the LL
command must be entered with the correct case.
ZMNTR will create the file if it does not already exist. It will overwrite
an existing file. If the file name is set to 1, ZMNTR will write to standard
out.
For example:
ZMNTR>ll
Listing to terminal
ZMNTR<11 1
Listing to standard out
ZMNTR<11 /home/test/output.file
Listing to: /home/test/output.file
MX - Display ACC Card Configuration
Format: MX, m1,m2, [opts]
The command displays the ACC interface card, port and subchannel
configurations for ACC cards in the range m1 to m2.