ACC Utilities Reference Guide

ZMNTR - ZCOM Runtime Monitor
Commands
Chapter 3 87
Example:
Display the NAM records from the firmware download file. This
command opens and reads the download file.
ZMNTR> mx 1 1 n
Interface card information for ACC ttgen input file
TTGEN source /opt/acc/cfg/loopback.answ
object /opt/acc/cfg/loopback.tmem
Mux:01 Bus:00/00 Slot:01 Trms:0009 Card Stat:Up and active
Hardware Revision: Rev.A
Firmware download file: /opt/acc/z7400a/loopback.zabs
Module: VMUX-1.1 Linktime: Wed Sep 10 05:43:06 1997
ROM-ID: Z7400A [01.B] Updated: Wed Apr 16 16:00:00 1997
Connection: RS232 panel MPU activity: 0%
VMUX-1.1 940329.1815 X.25 Download file for HP-UX Zcom System
UMUX302A 931027.1633 @(#)ZCOM System Firmware (SNAP) Rev 04.B 921106.1200>
WMUX1 940315.0251 @(#)ZCOM System Software (WMUX1) Rev 01.A 940228.1200>
WMUX3 940315.0251 @(#)ZCOM System Software (WMUX3) Rev 01.B 940304.1200>
WMUX4 940315.0252 @(#)ZCOM System Software (WMUX4) Rev 01.A 940228.1200>
LAPB 940329.1810 @(#)ZCOM LAP-B INTERRUPT CODE Rev 10.12 940328.1200>
HDLC 931027.1634 @(#)ZCOM HDLC PROTOCOL CODE Rev 3.2 930913.1000>
X25 940318.1548 @(#)ZCOM X.25 PROTOCOL CODE Rev 12.21 940318.0000>
MONITOR 931027.1634 @(#)ZCOM Monitor module Rev 2.1 930813.1500>
TESTPROT 931027.1634 @(#)ZCOM Port diagnostic module Rev 2.0 921029.1200>
PMENTTAB 931027.1634 @(#)ZCOM Protocol module entry point table 870406.1041>
UMUXENT 931027.1634 @(#)ZCOM System entry point table 911206.1153>
ZMNTR>
PT - Display Terminals on a Port
Format: PT,mm,pp
This command displays all the terminals on card mm port pp. If “all” or
“a” is specified instead of a port number, then all the terminals on card
mm will be displayed. Modifiers can be used with this command (enter
??,MOD for more information).
Example 1
ZMNTR> pt 1 0
ZLU# Mx p:sc Terminal Description.. Rx.Mes Tx.Mes Error E.Rate State.......
0009 01 0L00 L2 DCE 1 12 0 0.00% Up,Link Estbd
0548 01 0V00 SVCI =n/c No address 0 0 0 0.00% Dn,No Call