ACC Utilities Reference Guide

ZMNTR - ZCOM Runtime Monitor
Commands
Chapter 392
TT - Display Terminal Information
Format: TT,mm,nn,[name]
This command displays information about the terminals in the ZLU
range “mm” to “nn”.
The [name] parameter is optional. If specified, then only terminals whose
descriptions contain the string are shown.
The TT command may be immediately followed by one or more of the
command modifiers (See “Command Modifiers” on page 73).
Example
ZMNTR> tt 6 10
ZLU# Mx p:sc Terminal Description.. Rx.Mes Tx.Mes Error E.Rate State.......
0006 00 5L00 L2 DCE 1 5 0 0.00% Up,Link Estbd
0007 00 6L00 L2 DCE 1 5 0 0.00% Up,Link Estbd
0008 00 7L00 L2 DCE 1 5 0 0.00% Up,Link Estbd
0009 01 0L00 L2 DCE 1 5 0 0.00% Up,Link Estbd
0010 01 1L00 L2 DCE 1 5 0 0.00% Up,Link Estbd
**** ** ** Message totals 5 25 0 .00% ************
The headings used in the TT display have the following meanings:
ZLU# ZLU number of the terminal
Mx Mux number
p:sc Port and subchannel number for the terminal
Rx.Mes Number of received messages
Tx.Mes Number of transmitted messages
Errors Number of errors
E.Rate Error rate calculated using the formula:-
[Errors / (Rx.mes + Tx.mes)] x 100.
If this is not computable (i.e., errors >> 0 and Rx.mes +
Tx.mes = 0) then this field is filled with asterisks.
State Status of the terminal
The possible terminal states are divided into four groups which are
described in the following sections.
Normal Terminal States: