ACC Utilities Reference Guide

ZMNTR - ZCOM Runtime Monitor
Commands
Chapter 3 93
Down The terminal is enabled and activated but the line is
DOWN (or not connected). Usually a hardware
problem. There is nothing waiting on its transmit
queues.
Dn,Sending Terminal is same as “Down” above. In addition, there is
something pending in its transmit queues.
Deactivated The terminal is enabled but not activated. Messages
may usually be transmitted but not received from the
terminal. There may be protocol-specific exceptions to
this. Refer to a particular protocol’s User’s Guide for
details.
Disabled The terminal is disabled.
Not init The terminal has not been configured.
Unavailable The terminal is not available for use. Usually this
means that the ACC card is either absent or faulty, or
that the port has failed it’s selftest.
Up The terminal is enabled, activated and ready for
message transfer. Currently, there is no transmission
in progress.
Up,Sending The terminal is UP, and there are messages in the
terminal's queue in the process of being transmitted.
Up,SendSusp The terminal is UP. There are also messages waiting to
be transmitted, but such messages are not being
processed by the firmware, i.e. unacknowledged queue
is empty. This means the drivers suspended the
terminals transmission, e.g. hitting port limit.
X.25 Link Terminal States:
Disconcted X.25 link is disconnected
Clearing Link is in the process of being cleared
Local Clrd Link resetting (by local DTE)
Remote Clrd Link resetting (by remote DTE)
Link Estb Link level of X.25 is established
Disncting X.25 link in process of being disconnected