AD299A/AD355A Fibre Channel Mass Storage Adapters Installation Guide
Fibre Channel Adapter Installation for HP-UX
Prerequisites
Chapter 1
6
Prerequisites
Before installing the adapter, follow these steps:
Step 1. Verify compliance with supported configurations using the HP Fibre Channel Host Bus Adapter
Support Matrix at:
http://docs.hp.com/en/netcom.html#Fibre%20Channel
Step 2. Determine if the adapter is a Customer Replaceable Unit (CRU) using the HP Fibre Channel Host
Bus Adapter Support Matrix. If the adapter is not a CRU, contact your HP representative for
installation assistance.
Field Replaceable Units (FRUs) must be installed or replaced by qualified Hewlett-Packard service
representatives only. CRUs can be installed or replaced by customers or qualified Hewlett-Packard
service representatives.
Step 3. Check the following conditions:
• To verify that the /usr/bin, /usr/sbin, and /sbin directories are in the PATH, enter the
following command:
echo $PATH
• Verify that you have the following items:
— Grounding wrist strap
— Fibre Channel driver software media (included with the OS or application CD)
— Fibre Channel host bus adapter with an optical port protector attached (not included with
all adapters)
• Verify that you have the following cabling items:
— Fiber optic cable terminated with a duplex LC connector.
— Cable map (optional)