AD331A & AD332A PCI-X 1-Port Gigabit Ethernet Card Overview HP-UX Networking HP 9000 and HP Integrity Systems E0207 Printed in the USA © Copyright 2007 Hewlett-Packard Development Company, L.P.
Legal Notices The information in this document is subject to change without notice. Hewlett-Packard makes no warranty of any kind with regard to this manual, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. Hewlett-Packard shall not be held liable for errors contained herein or direct, indirect, special, incidental or consequential damages in connection with the furnishing, performance, or use of this material.
Product Overview Product Overview Product Overview The AD331A/AD332A PCI-X LAN cards have the following features and requirements: • PCI-X 133 MHz capable card can operate at 32-bit or 64-bit modes and is supported in the following frequencies: — PCI-X 133. Best performance is achieved by putting the card into one of the highest-performing (or “dual-rope”) PCI-X 133 slot.
Product Overview Product Overview • IPv4 TCP Segmentation Offload (TSO). TSO, also known as “large send” enables a system’s protocol stack to offload portions of outbound TCP processing to a network interface card thereby reducing system CPU utilization and enhancing performance. • LAN boot support on HP Integrity and HP 9000 (PA-RISC) systems except for rp7410 and rp8400. • Supports readout of Vital Product Data (VPD).
Product Overview Supporting Systems Supporting Systems For the list of systems that support this card and the ones that don’t, refer to the Ethernet Support Matrix on http://docs.hp.com. That matrix also tells which OEs support each card and the driver associated with each product.
Product Overview Supporting Systems 6
A Regulatory Information This appendix contains regulatory statements for the United States, Canada, Australia/New Zealand, Japan, and the European community. Card Physical and Environmental Specifications Following are the product physical and environmental specifications of the AD331A/AD332A PCI-X 1-Port Gigabit Ethernet Card. Physical Specifications Form Factor PCI half-card form-factor PCI-X (rev 2.3) PCI support 64-bit 3.3V only 133Mhz Width 6.4 cm (2.536 in) Length 16.9 cm (6.
Regulatory Information FCC Statement (For U.S.A.) Maximum kV (if less than 15 kV) with no loss of function 8 Maximum kV (if less than 25 kV) with no component damage 25 Operating Altitude 3,000 meters (9900) ft Non-operating Altitude 4,500 meters (14850 ft) FCC Statement (For U.S.A.) Federal Communications Commission Radio Frequency Interference Statement WARNING This device complies with Part 15 of the FCC rules.
Regulatory Information EMI Statement (European Community) EMI Statement (European Community) NOTE This is a Class A product. In a domestic environment, this product may cause radio interference, in which case you may be required to take adequate measures. Laser Safety Statements Laser Safety Statements - U.S. FDA/CDRH - Optical (laser) Transceiver CAUTION The optical transceiver provided on the network interface card contains a laser system and is classified as a “Class-I Laser Product” under a U.S.
Regulatory Information AD331A & AD332A Declaration of Conformance AD331A & AD332A Declaration of Conformance 10 Appendix A