ATM Configuration and Troubleshooting Guide

Configuring SVCs and PVCs
Configuring PVCs
Chapter 5 83
The modified PVC appears in the list of PVCs already configured.
Step 12. Exit SAM and verify that the PVC works, as described in “Verifying a
PVC’s Configuration” on page 83 (below).
Verifying a PVC’s Configuration
To verify that a PVC that you have added or modified works, follow these
steps:
Step 1. To display the configured VCs on the adapter, type this command:
atmmgr card_inst_num show -v
The output could look like this (note, this example is for a configuration
that includes LANE V2 and MPOA):
ATM/AAL vc information table
VPI,VCIPMP Type Use SEL Dest.IP Address AAL
Index Status
--------------------------------------------------------------
---------------
0,5 No PVC Signaling 00 N/A 5
0 Up
0,16 No PVC ILMI 00 N/A 5
0 Up
0,50 No SVC LEC_to_LECS/LES 37 N/A 5
0 Up
0,66 Leaf SVC LEC_to_LECS/LES 37 N/A 5
1 Up
0,82 No SVC LEC_to_BUS 37 N/A 5
0 Up
0,97 Leaf SVC LEC_to_BUS 37 N/A 5
1 Up
0,126 No SVC LEC_to_LECS/LES 16 N/A 5
0 Up
0,130 Leaf SVC LEC_to_LECS/LES 16 N/A 5
1 Up
0,135 No SVC LEC_to_BUS 8025 16 N/A 5
0 Up
0,138 Leaf SVC LEC_to_BUS 8025 16 N/A 5
1 Up
0,142 No SVC Classical_IP 00 - 5
0 Up
0,197 No SVC LLC LEC, MPC 01 * 5