ATM Configuration and Troubleshooting Guide

Configuring SVCs and PVCs
Configuring PVCs
Chapter 5 85
Step 5. Highlight the ATM adapter that you want to configure, and then choose
Configure from the “Actions” menu.
This opens the “Configure ATM Card” window, which lists all configured
interfaces for the ATM adapter.
Step 6. Highlight the IP (ip xx or cip xxx ) interface that you want to configure
and select Configure PVCs... from the “Actions” menu.
Step 7. Highlight the PVC that you want to remove and select the Remove...
button.
Step 8. Select the OK button when you are finished.
Using the Command atmmgr
See the atmmgr(1M) man pages for more information about how to
remove a PVC using the atmmgr add command.
Automatic Reconfiguration of PVCs
The configuration of all PVCs configured using SAM is recorded and
automatically reconfigured at system start-up if the Start at Init
parameter for the IP interface is set to yes.
Displaying Traffic Parameter Configurations
You can use the atmmgr card_inst_num show -t command, with the
card instance number (for example, 0), to display the traffic
configurations used by the ATM adapter.