ATM Configuration and Troubleshooting Guide
Configuring EMS High Availability over ATM
Chapter 690
ATM (EMS HA-ATM):
• “EMS High Availability Overview” on page 91.
• “Types of Recovery” on page 93.
• “Types of Failures Managed by EMS HA-ATM” on page 97.
• “Migrating from HA-ATM to EMS HA-ATM” on page 106.
• “Configuration Recommendations” on page 110.
• “Configuring EMS HA-ATM for Local Recovery” on page 112.
• “Configuring EMS HA-ATM for Remote Recovery (Using
MC/ServiceGuard)” on page 130.
• “Modifying ATM Parameters when Using EMS HA-ATM” on
page 136.
• “Stopping the Daemon” on page 138.
• “Unconfiguring EMS HA-ATM” on page 139.
Please note that this chapter describes how to configure EMS HA-ATM
for local recovery and remote recovery in an ATM network using HP
ATM adapters. It assumes that you are familiar with the following:
• Basic concepts of ATM and LAN Emulation.
• High Availability concepts.
• MC/ServiceGuard.
• The Event Monitoring Service (EMS).
For detailed information about MC/ServiceGuard, see Managing
MC/ServiceGuard. For detailed information about EMS, see Using EMS
HA Monitors.