ATM Configuration and Troubleshooting Guide

Getting Status Information with ATM Commands
Command Summary
Chapter 7 143
Command Summary
The commands you can use to get information about an ATM adapter,
the ATM network interfaces, and about ATM in general are described in
this section.
Getting Information about an ATM Adapter
To get information about a specific ATM adapter, you can use the
commands shown in Table 7-1 below.
Table 7-1 Commands for Getting ATM Adapter Information
To do this: Use this command:
Display information about
all active virtual circuits
atmmgr card_inst_num show -v
Display information about
a specific virtual circuit
atmmgr card_inst_num show -v vpi, vci
Display statistics for the
AAL interface
atmmgr card_inst_num show -a
Display ATM cell
statistics, the ATM
address, VCCs in use, and
the version of UNI
configured
atmmgr card_inst_num show -c
Display the status of the
adapter, theMAC address,
physical layer statistics,
and adapter medium
information
atmmgr card_inst_num show -p
Display use of traffic
parameter configurations
(SVCs and PVCs) for an
ATM adapter
atmmgr card_inst_num show -t