ATM Configuration and Troubleshooting Guide

Getting Status Information with ATM Commands
Command Summary
Chapter 7 147
Getting ATM Information
To get information about ATM in general, you can use the commands
shown in Table 7-4 below.
Note that net_interface is the name of the network interface; for
example, ela0, ela1 ... for HP-UX 10.20, or el101, el201... for HP-UX
11.X.
Table 7-4 Commands for Getting General ATM Information
To do this: Use this command:
HP-UX 10.20: Display IP
statistics and check traffic on an
ATM adapter
HP-UX 11.X: Display IP
statistics and check traffic on
ATM network interfaces
netstat -i
netstat -i
HP-UX 10.20: Display
information about networking
adapters that have been installed
For HP-UX 11.X: Display
information about networking
adapters that have been installed
and network interfaces that have
been configured
lanscan
lanscan
Check for bind errors ioscan -f
Check whether the local IP has
been set up correctly
ifconfig net_interface