ATM Configuration and Troubleshooting Guide

Getting Status Information with ATM Commands
Command Examples
Chapter 7148
Command Examples
The following sections provide examples of the commands you can use to
monitor your ATM system.
Getting Information for All Active Virtual Circuits
You can get information on all currently active virtual circuits for an
adapter, and also check SVC and PVC connections with other systems.
Both Classical IP and LAN Emulation virtual circuits are listed.
The following command is used to check the VCs on an adapter (using a
card instance number of 0):
atmmgr 0 show -v
This output example—which is for a configuration that includes LANE
V2 and MPOA—shows all VCs for an ATM adapter that has three
interfaces configured—one Classical IP and two LAN Emulation
(indicated by values in the “SEL” field, which correspond to what was
entered in the LEC selector field in SAM):
ATM/AAL vc information table
VPI,VCI PMP Type Use SEL Dest.IP Address AAL Index Status
---------------------------------------------------------------------------
0,5 No PVC Signaling 00 N/A 5 0 Up
0,16 No PVC ILMI 00 N/A 5 0 Up
0,100 No PVC Classical_IP 00 5 3 Up
0,194 No SVC LEC_to_LECS/LES 56 N/A 5 0 Up
0,196 Leaf SVC LEC_to_LECS/LES 56 N/A 5 1 Up
0,198 No SVC LEC_to_BUS 56 N/A 5 0 Up
0,200 Leaf SVC LEC_to_BUS 56 N/A 5 1 Up
0,201 No SVC LEC_to_LEC 56 N/A 5 2 Up
0,202 No SVC LLC LEC, MPC 56 * 5 0 Up
0,203 No SVC LLC LEC, MPC 56 * 5 0 Up
0,204 No SVC LEC_to_LECS/LES 02 N/A 5 0 Up
0,205 Leaf SVC LEC_to_LECS/LES 02 N/A 5 1 Up
0,206 No SVC LEC_to_BUS 8025 02 N/A 5 0 Up
0,207 Leaf SVC LEC_to_BUS 8025 02 N/A 5 1 Up
0,208 No SVC LEC_to_LEC 8025 02 * 5 2 Up