ATM Configuration and Troubleshooting Guide

Getting Status Information with ATM Commands
Command Examples
Chapter 7162
MPC Egress Cache Table for LEC interface el100:
MPC Egress Cache Table for Primary LEC:
MPS MAC
(MPS Router)
Address IPV4 Address Ingress MPC Address
------------ -------------- ------------------------------------------
080910010203 192.234.118.67 47010203040506070809101112.010203040506.99
47010203040506070809101112.010203040506.98
Entry State : negative
Cache ID : 800
Egress Cache Tag : 0x1234567812345678
Service Category : 198
Holding Time : 10mn
Prefix Length : 43
DataLink Header : 00 b1 82 03 04 05 06 07 08 09 10 ef 80 00
MPOA Routers (MPOA Servers) Table for LEC interface el100:
MPOA Routers (MPOA Servers) Table for Primary LEC:
MPS MAC
(MPS Router)
Address Router MPS Address
------------ ------------------------------------------
080900010203 47010203040506070809101112.010203040506.99
080901010101 47010203040506070809101112.010203040506.99
080910010203 47010203040506070809101112.010203040506.99
080901010102 47010203040506070809101112.010203040506.99
Getting Adapter IP Statistics and Traffic (HP-UX
10.20)
To check traffic on a system, use the netstat -i command, as follows:
netstat -i
The output from the command is as follows, for HP-UX 10.20:
Name Mtu Network Address Ipkts Ierrs Opkts Oerrs Coll
ni0* 0 none none 0 0 0 0 0