ATM Configuration and Troubleshooting Guide

Getting Status Information with ATM Commands
Command Examples
Chapter 7166
You can also use the ioscan command to identify the number of ATM
adapters in the system; in the Class column of the above output, two
ATM adapters (card instances 0 and 1) are present.
Determining the Type of an ATM Adapter
To determine the type (HP-HSC or HP-PCI) of an ATM adapter, use the
following command:
ioscan -fCatm
Then, in the command’s output, check to see which name is listed in the
Driver column for the ATM adapter you are trying to identify. Look up
the driver name in Table 7-5 below to determine which ATM adapter it is
(discontinued adapters—and the corresponding drivers—are not shown).
Table 7-5 Determining an ATM Adapter’s Type
Driver
Name
Type and Product Number of
Corresponding ATM Adapter
atm2gsc HP-HSC 155 J2469A (MMF, UTP5, or
SMF)
HP-HSC 155 J2499A (MMF or UTP5)
HP-HSC 155 J3420B (MMF)
HP-HSC 622 J3573A (MMF)
atm2pci HP-PCI 155 A5513A (MMF)
HP-PCI 155 A5515A (UTP5)
HP-PCI 622 A5483A (MMF)