ATM Configuration and Troubleshooting Guide

Troubleshooting
Troubleshooting Classical IP
Chapter 9 205
H Check the remote system’s configuration. Using the configuration
software provided with the remote system’s ATM adapter, check that the
PVC has been configured correctly. Ensure that the same traffic
parameters are configured on both the local and remote systems.
I Correct the configuration. If the remote system’s configuration is not
correct, use the configuration softwareprovided with the remote system’s
ATM adapter to add or modify the PVC.
J Check if remote IP interface is set up correctly. Ensure that the IP
interface has been set up correctly on the remote system.
K Correct the configuration. If the remote system’s IP interface is not
correct, use the remote system’s configuration software to correct it. If
the remote system is an HP-UX system, use SAM.
L Call HP. Refer to “Contacting Your HP Representative” on page 281
before calling HP.