ATM Configuration and Troubleshooting Guide

Troubleshooting
Troubleshooting Classical IP
Chapter 9216
Figure 9-5 Flowchart for Checking a Local ARP Client
No
Yes
OK?
OK?
OK?
OK?
Yes
No
Yes
OK?
OK?
Use SAM to check if
Reconfigure ATM address
of ARP server with SAM
Check that ARP server is
operational and configured
as the ARP server
Configure the
ARP server
On ARP server, check
that local ATM adapter is
registered in ARP table
Check that SVC
to server is open
On ARP server, check
that destination node is
registered in ARP table
Check ATM connectivity
for server and switch
Check if local IP and ATM
addresses are valid
Change address
Yes
No
No
No
No
Yes
Yes
See remote
Use atminit -net
net_interface
system
ATM address of server
is entered correctly
Start
A
B
C
D
E
F
G
G
See NetTL log
file for problem