ATM Configuration and Troubleshooting Guide

Troubleshooting
Troubleshooting LAN Emulation
Chapter 9238
NOTE When an ATM-connected device is communicating with a legacy LAN
device, use traditional Ethernet or Token Ring LAN troubleshooting
procedures to troubleshoot the legacy LAN device. Use the edge device’s
troubleshooting procedures to troubleshoot the edge device connected to
the legacy LAN device; this ensures that everything on the legacy LAN
side is working correctly. Then, use the troubleshooting procedures
described below to troubleshoot the connection between the
ATM-connected device and the ATM-connected edge device.
A Type elstat -n net_interface -v to get information on the ELAN that
corresponds to the IP interface, and its configured backup services (if
any). The output looks like this, for example (note, this example is for a
configuration that includes LANE V2 and MPOA):
Primary LEC configuration and status information
ATM Address : 47000580ffe1000000f124121f.080009c6fca2.00
LLC multiplexed
ATM address : 47000580ffe1000000f124121f.080009c6fca2.01
MAC address : 080009123456
Local Segment ID : 000
ELAN name : MKTG
Status : Operational
State : Current
LECS’s ATM Address : 47000580ffe1000000f21a1e28.0020481a1e28.05
(Manual entry)
Configuration Direct VCC : -,-
LES’s ATM Address : 47000580ffe1000000f21a1e28.0020481a1e28.10
Control Direct VCC : 0,110
Control Distribute VCC : 0,255
BUS’s ATM Address : 47000580ffe1000000f21a1e28.0020481a1e28.11
Multicast Send VCC : 0,113
Multicast Forward VCC : 0,253
Maximum Data Frame Size : 1516bytes
Control Timeout : 120s
Vcc Timeout Period : 1200s
Maximum Retry Count : 1