ATM Configuration and Troubleshooting Guide

Conﬁguring LAN Emulation Interfaces

Verifying the ELAN Interface Conﬁguration

Chapter 458

Multicast Send VCC : 0,113

Multicast Forward VCC : 0,253

Maximum Data Frame Size : 1516bytes

Control Timeout : 120s

Vcc Timeout Period : 1200s

Maximum Retry Count : 1

Aging Time : 300s

Expected Arp Response Time : 1s

Flush TimeOut : 4s

Maximum Unknown Frame Count : 1

Maximum Unknown Frame Time : 1s

Connection Complete Timer : 4s

LEC Initial Control Timeout : 10s

LEC Control Timeout Multiplier : 5s

LEC V2 Max Unknown Frame Count : 3

LEC Config Local Segment ID : 345

LEC Config V2 Capable : LUNI (LANE V2)

LEC Config Selective Multicast : Yes

LEC Forward Disconnect Timeout : 300s

LEC Min Reconfigure Delay : 1000s

LEC Max Reconfigure Delay : 2000s

LEC Max Bus Connect Retries : 2

LEC Token Ring Explorer Frame Excluded : exclude

LEC Preferred LES Addr :

47000580ffe1000000f21a1e28.0800092c6de1.16

NOTE The line Local Segment ID (shown as bold in the above example) is

displayed for only Token Ring networks. A value of 000 indicates that

transparent mode is being used. If source routing is being used, the

number of the ring is displayed in this ﬁeld.

The Primary LEC Status is shown as “Operational” and the State is

shown as “Current” when the adapter has successfully joined the ELAN

(all VCCs are open). If conﬁgured, the Secondary LEC status is displayed

as “Operational” and the State is shown as Backup” when the secondary

LAN Emulation services are operational.

Step 2. To test that the ELAN interface can transmit and receive data correctly,

type this command:

ping

destination_LEC_IP_address