ATM Configuration and Troubleshooting Guide

Configuring SVCs and PVCs
Configuring PVCs
Chapter 578
Example of PVC/ATM Switch Configuration
Figure 5-2 below is an example of a PVC and ATM switch configuration.
Figure 5-2 Example of a PVC and ATM Switch Configuration
To connect systems A, B, and C using PVCs, configure the PVCs on the
systems as follows:
For simplicity, the example uses the same VPI and VCI numbers on both
systems (for example, PVC 0,101 on System A and System B).
The VC matrix for this example is shown in Table 5-6 below.
ATM Switch
System A
System B
System C
A1 A2
A3
Table 5-5 Example of PVC Configuration
On System VPI,VCI
Destination
System
A 0,101
0,102
System B
System C
B 0,101
0,103
System A
System C
C 0,102
0,103
System A
System B