FibrChanl-01 (fcd) B.11.23.0807 Fibre Channel Mass Storage Driver Release Notes, Edition 2.0 (July 2008)

ManualsBrandsHP ManualsNetwork HardwareHP-UX 11i v2 I/O Cards

FibrChanl-01 (fcd) Fibre Channel Mass

Storage Driver for HP-UX 11i v2 Release

Notes

Version Number B.11.23.0807

HP Part Number: J6374-90071

Published: July 2008

Edition: 2.0

Summary of content (8 pages)

PAGE 1
FibrChanl-01 (fcd) Fibre Channel Mass Storage Driver for HP-UX 11i v2 Release Notes Version Number B.11.23.0807 HP Part Number: J6374-90071 Published: July 2008 Edition: 2.
PAGE 2
PAGE 3
This document provides information about the B.11.23.0807 release of the FibrChanl-01 (fcd) Fibre Channel Mass Storage Driver for HP-UX 11i v2. FibrChanl-01 (fcd) Fibre Channel Mass Storage Driver for HP-UX 11i v2 Overview This release of the FibrChanl-01 (fcd) Fibre Channel Mass Storage Driver for HP-UX 11i v2 (version B.11.23.0807) provides fixes for several defects. New and Changed Features in This Release New Features The following features are new with the B.11.23.
PAGE 4
6. • Look for EFI 1.49 for adapters A6826A, A9782A, A9784A, and AB465A. Look for EFI 1.05 for adapters AB378A and AB379A. Configuring an Alternate Path on the Same 2–Port HBA as the Primary Path On midrange and high end Integrity servers, if the primary and alternate boot devices are on the same Fibre Channel HBA port, an attempt to manually boot from the alternate device will fail. For example, if your primary and alternate paths are set as follows: Primary bootpath: 0/0/10/1/0/4/0.8.0.255.0.7.
PAGE 5
Compatibility and Installation Requirements This section describes the compatibility information and installation requirements for this release. For specific installation instructions, refer to the installation guide specific to your to your FibreChannel card. Operating System and Version Compatibility The following software (or later versions) must be installed before installing the FibrChanl-01 (fcd) driver, version B.11.23.0807 into a system: • • • • • • • FibrChanl-00 (td) version B.11.23.
PAGE 6
NOTE: vpd Display EFI driver and ROM firmware versions using fcmsutil EFI/firmware bundles can be downloaded from www.hp.com, in the Software and Driver Downloads section. Hardware Requirements This version of the FibrChanl-01 (fcd) Fibre Channel Mass Storage Driver for HP-UX 11i v2 runs on HP Integrity servers with the HP-UX 11i v2 (11.23) operating system.
PAGE 7
PAGE 8
*J6374-90071* Printed in the US