HP A6829A PCI Dual Channel Ultra160 SCSI Host Bus Adapter Service and User Guide (May 2003)

Installing the A6829A Adapter

Chapter 2 15

Installing the A6829A Adapter

This section contains information about installing the A6829A HBA in

an HP-UX system (including Online Addition and Replacement [OLAR]).

WARNING The installation procedures in this section require opening the

computer cabinet, which might expose you to high-energy

(high-amperage) circuits and sharp edges in the equipment

chassis. Be sure to remove all rings, watches, and other jewelry

before opening the cabinet.

CAUTION The A6829A adapter contains electronic components that can easily be

damaged by small amount of static electricity. To avoid damage, follow

these guidelines:

• Store the adapter in its antistatic plastic bag until you are ready to

install it.

• Work in a static-free area, if possible.

• Handle the adapter by the edges only. Do not touch electronic

components or electrical traces.

• If you must lay the adapter down, place it on a non-conductive mat or

surface.

• Use the ESD kit that is provided with the adapter. Follow the

instructions included with the kit.

• Use a suitable ground—any exposed metal surface on the system

chassis.

Before beginning installation, and without removing the adapter from its

antistatic bag, inspect the adapter for any signs of obvious damage, such

as chipped or loose components. Contact Hewlett-Packard if the adapter

is damaged.

Install the A6829A in your HP-UX system according to the

documentation for the system.