HP A6829A PCI Dual Channel Ultra160 SCSI Host Bus Adapter Service and User Guide (May 2003)

Installing the A6829A Adapter
Specifying SCSI Parameters
Chapter 238
NOTE If you set a particular maximum data transfer rate to the SCSI controller
(in this example, 53C1010-66), then the same maximum data transfer
rate is set to all the devices.
This happens because all the devices are connected to the same SCSI
bus, which is controlled by the SCSI controller.
Step 6. After making the necessary changes, press the [ESC] key to exit the
Device Properties screen. This takes you back to the Adapter Properties
screen.
Step 7. Press the [ESC] key to exit the Adapter Properties screen.
If you did not modify any of the SCSI parameters, then the Global
Properties screen appears.
However, if you modified any of the SCSI parameters, then the following
screen appears:
Adapter and/or device property changes have been made.
<Cancel Exit>
<Save changes then exit this menu>
<Discard changes then exit this menu>
Exit the Configuration Utility
Use the arrow keys to highlight your selection from the listed choices,
and then press the [ENTER] key to return to the Global Properties
screen.
Step 8. Press the [ESC] key. This displays the following screen:
Are you sure you want to exit?
<Cancel Exit>
Save changes then exit this menu
Discard changes then exit this menu
<Exit the Configuration Utility>
Use the arrow keys to highlight your selection from the listed choices,
and then press the [ENTER] key to return to the EFI shell prompt.