HP A6829A PCI Dual Channel Ultra160 SCSI Host Bus Adapter Service and User Guide (May 2003)

Installing the A6829A Adapter
Specifying SCSI Parameters
Chapter 2 53
Setting SCSI Parameters to Default Values
You can set the SCSI parameters, except Auto Termination, for the
adapter to their default values through the BCH menus. The steps you
follow depend on the type of HP-UX system in which the adapter is
installed.
hp servers rp7410, rp8400, and superdome
On hp servers rp7410, rp8400, and superdome, set the SCSI parameters
to the default values by performing the following steps:
Step 1. If you are already at the “Main Menu,” type ser (for “Service Menu”); go
to step 2.
If you are not at the “Main Menu,” type main (to return to the “Main
Menu”), type ser (for “Service Menu”), and then go to step 2.
Step 2. In the “Service Menu,” type the following command:
scsi path default
where, path is the HBA’s path. This sets all of the SCSI parameters for
the path to their default values.
Step 3. Type main to get back to the “Main Menu.”
All Other Servers
On all servers other than hp servers rp7410, rp8400, and superdome, set
the SCSI parameters to the default values by following the steps for
specifying each SCSI parameter (described earlier in this section).
You will need to know the default value—and how to specify it—for each
SCSI parameter. To know the valid SCSI parameter values, HP
recommends you to use the online help for the scsi command (type
help scsi when you are in the BCH “Service Menu”).