HP A6829A PCI Dual Channel Ultra160 SCSI Host Bus Adapter Service and User Guide (May 2003)

Installing the A6829A Adapter

Installing the SCSI Driver

Chapter 2 55

If you need to install one or more patches, go to step 2.

Step 2. Install any necessary patches.

Step 3. Follow the normal procedure to install the appropriate software bundle

for your HP-UX system’s OS or OE.

Step 4. Issue the swlist command to ensure that the necessary patches and the

c8xx driver are present.

Step 5. Check to see if the c8xx driver is loaded in the kernel, by doing one of the

following two things:

• Use SAM, as follows:

1. Select the “Kernel Conﬁguration” icon.

2. Select the “Drivers” icon.

3. In the “Kernel Conﬁguration” screen, check to see if the c8xx

driver is in the kernel.

• Issue the following command:

what /stand/vmunix | grep scsi_c8xx.c

Check to see if the c8xx driver is listed.

If the driver is in the kernel, go to the section, “Conﬁguring LUN 0” on

page 55.

If the driver is not in the kernel, go to step 6

Step 6. Load the c8xx driver into the kernel through SAM:

a. Select the “Kernel Conﬁguration” icon.

b. Select the “Drivers” icon.

c. In the “Kernel Conﬁguration” screen, follow the normal steps for

loading the driver into the kernel (and building a new kernel).

NOTE You need to reboot the system after completing these steps.

Once you have conﬁrmed that the c8xx driver is in the kernel, go to

section, “Conﬁguring LUN 0” on page 55.