HP A6829A PCI Dual Channel Ultra160 SCSI Host Bus Adapter Service and User Guide (May 2003)

Installing the A6829A Adapter

Using the EFI Flash Utility

Chapter 2 63

The EFI utility should be executed from a diskette or CD-ROM. For EFI

based systems without a ﬂoppy diskette drive, burning the EFI utility

and other ﬁrmware images onto a CD-ROM allows proper execution, but

with reduced functionality. In such a situation, you will not be able to

save an image of the ﬂash memory to the CD-ROM.

Preparation

While booting the EFI enabled systems, the diskette or CD-ROM

containing the EFI utility needs to be in the drive to allow device

mapping. The EFI utility and ﬁrmware image ﬁles are located in the root

directory or in a subdirectory on the diskette or CD-ROM.

Boot the system to the EFI shell prompt. The ﬂoppy diskette drive or

CD-ROM drive should appear in the list of mapped devices as fs0.

In systems with a ﬂoppy drive, type fs0 at the EFI shell prompt to

change to this device.

Menu Driven Mode

If the EFI utility and ﬁrmware image ﬁles are located in the root

directory, enter the efi8xxfl command at the prompt as illustrated

below; otherwise, move to the directory in which these ﬁles are located

and continue.

fs0:\> efi8xxfl

The following main window screen appears:

Vendor Device

Choice ID ID Seg Bus Dev Func Flash Part

------- -------- -------- ------- ------ ------ ------- ------------

1 0x1000 0x021 0x00 0x15 0x01 0x00 M29F010B

LSI Logic, Inc. SYMC1010 Ultra160 66Mhz SCSI

2 0x1000 0x021 0x00 0x15 0x01 0x01 M29F010B

LSI Logic, Inc. SYMC1010 Ultra160 66Mhz SCSI

3 0x1000 0x021 0x00 0x3F 0x01 0x00 Am29F010

LSI Logic, Inc. SYMC1010 Ultra160 66Mhz SCSI

4 0x1000 0x021 0x00 0x3F 0x01 0x01 Am29F010

LSI Logic, Inc. SYMC1010 Ultra160 66Mhz SCSI