HP A6829A PCI Dual Channel Ultra160 SCSI Host Bus Adapter Service and User Guide (May 2003)

Troubleshooting
Setting and Confirming SCSI Parameters
Chapter 376
The SCSI Command
The SCSI command can be used to display and set SCSI bus parameters
to ensure that the SCSI adapter is compatible with the SCSI devices.
Displaying Transfer Rates
To display the SCSI transfer rate for an adapter using the SCSI
command, use the following syntax:
SCSI rate bus_number slot_number
where
bus_number Specifies the number of the bus on which the adapter is
installed.
slot_number Specifies the number of the slot the adapter is in.
For example:
• To display the SCSI transfer rate for an adapter installed on bus 5
slot 2, issue the following command:
SCSI rate 5 2
The command displays the following output:
PCI device /5.2 = no limit
• To list transfer rates for all the bus and slot numbers, issue the
following command:
SCSI rate