HP A6829A PCI Dual Channel Ultra160 SCSI Host Bus Adapter Service and User Guide (May 2003)

Troubleshooting
Setting and Confirming SCSI Parameters
Chapter 378
Displaying SCSI IDs
To display the initiator SCSI IDs for an adapter using the SCSI
command, use the following syntax:
SCSI init bus_number slot_number
where
bus_number Specifies the number of the bus on which the adapter is
installed.
slot_number Specifies the number of the slot the adapter is in.
For example:
• To display the SCSI ID for an adapter on bus 5 slot 2, issue the
following command:
SCSI init 5 2
The command displays the following output:
PCI device /5.2 = 7
• To list the SCSI IDs for all the bus and slot numbers, issue the
following command:
SCSI init