HP A6829A PCI Dual Channel Ultra160 SCSI Host Bus Adapter Service and User Guide (May 2003)

Troubleshooting
Setting and Confirming SCSI Parameters
Chapter 3 79
Setting SCSI ID
To set the initiator SCSI ID for an adapter using the SCSI command, use
the following syntax:
SCSI init bus_number slot_number ID_number
where
bus_number Specifies the number of the bus on which the adapter is
installed.
slot_number Specifies the number of the slot the adapter is in.
ID_num Specifies the adapter’s SCSI ID number.
For example, to set the SCSI ID for an adapter installed on bus 5 slot 2 to
6, issue the following command:
SCSI init526
To display the result, issue the following command:
SCSI init 5 2
The output is as follows:
PCI device /5.2 = 6