HP A6829A PCI Dual Channel Ultra160 SCSI Host Bus Adapter Service and User Guide (May 2003)

Troubleshooting
Setting and Confirming SCSI Parameters
Chapter 382
LSI Logic Host Bus Adapters
Adapter PCI PCI PCI IRQ NVM LSI Logic
Bus Device Function Control
<53C875 60 01 01> 0 Yes Enabled
Press the [Enter] key. This displays the Adapter Properties screen
containing the controller (HBA) settings; refer to the following example:
Adapter Properties
Adapter PCI PCI PCI
Bus Device Function
53C875 60 01 01
<Device Properties>
Boot Support [Enabled]
SCSI Parity [Yes]
Host SCSI ID [ 5]
SCSI Bus Scan Order [Low to High (0..Max)]
Spinup Delay (Secs) [ 2]
Secondary Cluster Server [Yes]
Termination Control [Auto]
<Restore Defaults>
Use the arrow keys to highlight the different SCSI parameters.
Use the plus (+) and minus (-) keys to change the highlighted SCSI
parameter.
NOTE Modify only the Host SCSI ID and the Secondary Cluster Server
parameters, if necessary.
Set the Secondary Cluster Server to Yes if more than one initiator is
connected to the SCSI bus.
Do not change the default values of other SCSI parameters listed on the
screen.