HP A6829A PCI Dual Channel Ultra160 SCSI Host Bus Adapter Service and User Guide (May 2003)

Troubleshooting
Setting and Confirming SCSI Parameters
Chapter 3 83
Step 5. Press the [ESC] key to exit the Adapter Properties screen.
If you did not modify any of the SCSI parameters, then the Global
Properties screen appears.
However, if you modified any of the SCSI parameters, then the following
screen appears:
Adapter and/or device property changes have been made.
<Cancel Exit>
<Save changes then exit this menu>
<Discard changes then exit this menu>
Exit the Configuration Utility
Use the arrow keys to highlight your selection from the listed choices,
and then press the [ENTER] key to return to the Global Properties
screen.
Step 6. Press the [ESC] key. This displays the following screen:
Are you sure you want to exit?
<Cancel Exit>
Save changes then exit this menu
Discard changes then exit this menu
<Exit the Configuration Utility>
Use the arrow keys to highlight your selection from the listed choices,
and then press the [ENTER] key to return to the EFI shell prompt.
Step 7. At the EFI shell prompt, issue the following command to reboot the
system:
reset
NOTE The system reboot is required for the new setting to take effect.