HP A7143A RAID160 SA Controller Support Guide

Troubleshooting

The sautil Command

Chapter 6118

sautil <device_file>

The sautil <device_file> command output provides detailed

information on the RAID 160 SA controller, any logical drives that have

been configured, and all SCSI devices that are attached to the controller.

There is a -s option for this command that provides a shorter and less

detailed output. An example of the sautil <device_file> -s command

output can be found in “RAID160 SA Controller Firmware” on page 74.

For troubleshooting purposes the sautil <device_file> command,

illustrated in the following example, is preferable....the Logical Drive

Summary and the SCSI Device Summary, which have been highlighted

for emphasis, are particularly useful for troubleshooting:

# sautil /dev/ciss6

******************************************************************************

**** ****

**** S A U T I L S u p p o r t U t i l i t y ****

**** ****

**** for the HP A7143A RAID160 SA SCSI Adapter ****

**** ****

**** version A.01.01 ****

**** ****

******************************************************************************

---- DRIVER INFORMATION ------------------------------------------------------

Driver State........................ READY

---- ADAPTER INFORMATION -----------------------------------------------------

Adapter............................. HP A7143A RAID160 SA SCSI Adapter

Hardware Path....................... 0/6/0/0

Serial Number....................... P2313ADDAOVCDK

Device File......................... /dev/ciss6

Hardware Revision................... ’A’

Boot Block Revision................. 3.24

Firmware Revision (running)......... 2.92

Firmware Revision (in ROM).......... 2.92