HP A7143A RAID160 SA Controller Support Guide

Troubleshooting
The sautil Command
Chapter 6120
Logical Drive Status................ OK
# of Participating Physical Disks... 2
Participating Physical Disk(s)...... Ch:ID
1: 0
1: 1
Participating Spare Disk(s)......... Ch:ID
1: 2
1: 3
Stripe Size......................... 64 KB
Logical Drive Cache Status.......... cache enabled
Configuration Signature............. 0xA79C46BC
Media Exchange Detected?............ no
---- SCSI DEVICE 1:0 ---------------------------------------------------------
Channel Number................................... 1
SCSI ID.......................................... 0
Device Type...................................... DISK
Disk Capacity.................................... 18.2 GB
Device Status.................................... OK
Device Vendor ID................................. COMPAQ
Device Product ID................................ BD0186459A
Device Serial Number............................. UFL0P14000K90117
Device Firmware Version.......................... B016
SCSI Transfer Rate............................... Ultra 160
Reserved Area (cfg/status info).................. 557.1 KB (0.6 MB)
Block Size (bytes/sector)........................ 512 bytes
HP Disk Stamped?................................. yes
Last Failure Reason.............................. none
Physical Disk Flags:
Disk present and operational................... yes
Non-disk device detected....................... no
Wide SCSI transfer enabled..................... yes
Synchronous (Fast/Ultra) transfer enabled...... yes
Narrow disk tray detected...................... no
Wide transfer failed, reverted to narrow....... no
Ultra SCSI transfer enabled.................... yes
Ultra-2 SCSI transfer enabled.................. yes
S.M.A.R.T. supported........................... yes
S.M.A.R.T. errors (in factory M&P data)........ no