HP A7143A RAID160 SA Controller Support Guide

Troubleshooting
The sautil Command
Chapter 6 121
S.M.A.R.T. enabled............................. yes
S.M.A.R.T. errors (in powerup M&P data)........ no
Attached to external channel................... yes
Configured in a logical drive.................. yes
Configured as a spare disk..................... no
Disk write cache enabled at spin up............ no
Running in DT clocking mode.................... yes
Supports DT clocking mode only................. no
Supports DT and ST clocking modes.............. yes
Running in U320 mode........................... no
Packetized SCSI supported...................... no
Supports redundant adapter operation........... yes
Disk write cache enabled in current page....... no
Disk write cache disabled in default page...... yes
QAS capable (U320 only)........................ no
Currently running QAS (U320 only).............. no
---- SCSI DEVICE 1:1 ---------------------------------------------------------
Channel Number................................... 1
SCSI ID.......................................... 1
Device Type...................................... DISK
Disk Capacity.................................... 18.2 GB
Device Status.................................... OK
Device Vendor ID................................. COMPAQ
Device Product ID................................ BD0186459A
Device Serial Number............................. UFL0P14000KG0117
Device Firmware Version.......................... B016
SCSI Transfer Rate............................... Ultra 160
Reserved Area (cfg/status info).................. 557.1 KB (0.6 MB)
Block Size (bytes/sector)........................ 512 bytes
HP Disk Stamped?................................. yes
Last Failure Reason.............................. none
Physical Disk Flags:
Disk present and operational................... yes
Non-disk device detected....................... no
Wide SCSI transfer enabled..................... yes
Synchronous (Fast/Ultra) transfer enabled...... yes
Narrow disk tray detected...................... no
Wide transfer failed, reverted to narrow....... no
Ultra SCSI transfer enabled.................... yes