HP A7143A RAID160 SA Controller Support Guide

ManualsBrandsHP ManualsNetwork HardwareHP-UX 11i v2 I/O Cards

111

112

113

114

115

116

117

118

119

120

Troubleshooting

The sautil Command

Chapter 6122

Ultra-2 SCSI transfer enabled.................. yes

S.M.A.R.T. supported........................... yes

S.M.A.R.T. errors (in factory M&P data)........ no

S.M.A.R.T. enabled............................. yes

S.M.A.R.T. errors (in powerup M&P data)........ no

Attached to external channel................... yes

Configured in a logical drive.................. yes

Configured as a spare disk..................... no

Disk write cache enabled at spin up............ no

Running in DT clocking mode.................... yes

Supports DT clocking mode only................. no

Supports DT and ST clocking modes.............. yes

Running in U320 mode........................... no

Packetized SCSI supported...................... no

Supports redundant adapter operation........... yes

Disk write cache enabled in current page....... no

Disk write cache disabled in default page...... yes

QAS capable (U320 only)........................ no

Currently running QAS (U320 only).............. no

---- SCSI DEVICE 1:2 ---------------------------------------------------------

Channel Number................................... 1

SCSI ID.......................................... 2

Device Type...................................... DISK

Disk Capacity.................................... 18.2 GB

Device Status.................................... SPARE

Device Vendor ID................................. COMPAQ

Device Product ID................................ BD0186459A

Device Serial Number............................. UFL0P140008V0117

Device Firmware Version.......................... B016

SCSI Transfer Rate............................... Ultra 160

Reserved Area (cfg/status info).................. 557.1 KB (0.6 MB)

Block Size (bytes/sector)........................ 512 bytes

HP Disk Stamped?................................. yes

Last Failure Reason.............................. none

Physical Disk Flags:

Disk present and operational................... yes

Non-disk device detected....................... no

Wide SCSI transfer enabled..................... yes