HP A7143A RAID160 SA Controller Support Guide

Installing the RAID160 SA Controller
Installing the RAID160 SA Controller Hardware (Offline)
Chapter 4 57
Installing the RAID160 SA Controller
Hardware (Offline)
1. Disconnect any peripheral devices from the server.
2. Remove or open the access panel on the server.
3. Select an available 66-MHz PCI slot. Slots that use a 64-bit interface
may provide higher performance.
4. Remove the slot cover or open the hot-plug latch. Save the retaining
screw, if one is present.
5. Slide the controller board along the slot alignment guide.
Figure 4-1 Installing the HP A7143A RAID160 SA controller
NOTE Your server may look slightly different from the one illustrated
6. Press the controller board firmly into the slot so the contacts on the
board edge are properly seated in the system board connector.
7. Secure the board in place with the hot-plug latch or retaining screw.