HP A7143A RAID160 SA Controller Support Guide

Installing the RAID160 SA Controller
RAID160 SA Controller OLAR Error Recovery
Chapter 4 65
3. Now, disconnect the SCSI cable(s) from the controller and click
“YES”. The following message will be appear (see Figure 4-6, “SCSI
Cable Reconnect Note,”):
Figure 4-6 SCSI Cable Reconnect Note
4. Now connect the SCSI cable(s) to the controller, click “OK”, and run
sautil /dev/cissxx reset_adapter. After the reset operation is
completed, the controller will be operational.