HP A7143A RAID160 SA Controller Support Guide

Installing the RAID160 SA Controller
Verifying the Installation
Chapter 4 73
Step 2. Issue the ioscan -kfn | grep ciss command:
ioscan -kfn | grep ciss
If the RAID160 SA controller software is installed correctly, the
generated output will look similar to this:
# ioscan -kfn | grep ciss
ext_bus 6 0/6/2/0 ciss CLAIMED INTERFACE PCI 4-Channel
RAID160 SA SCSI controller (A7143A)
/dev/ciss6
If the software is not installed correctly, re-install it using swinstall
(see “Installing Software for the RAID160 SA Controller” on page 53).