HP A7143A RAID160 SA Controller Support Guide

Installing the RAID160 SA Controller
RAID160 SA Controller Firmware
Chapter 476
Determining the RAID160 SA Device File
The device file for the RAID160 SA controller can be determined from
the output of the ioscan -kfn command. An example of a portion of the
ioscan -kfn output listing the RAID160 SA device file follows:
# ioscan -kfn
Class I H/W Path Driver S/W State H/W Type Description
=============================================================================
root 0 root CLAIMED BUS_NEXUS
ioa 0 0 sba CLAIMED BUS_NEXUS System Bus Adapter
(582)
ba 0 0/0 lba CLAIMED BUS_NEXUS Local PCI Bus
Adapter (782)
lan 0 0/0/0/0 btlan CLAIMED INTERFACE HP PCI
10/100Base-TX Core
/dev/diag/lan0 /dev/ether0 /dev/lan0
target 2 0/0/1/1.15 tgt CLAIMED DEVICE
disk 0 0/0/1/1.15.0 sdisk CLAIMED DEVICE HP
73.4GMAN3735MC
/dev/dsk/c1t15d0 /dev/rdsk/c1t15d0
ext_bus 6 0/6/0/0 ciss CLAIMED INTERFACE PCI 4-Channel
RAID160 SA SCSI Adapter (A7143A)
/dev/ciss6
target 7 0/6/0/0.0 tgt NO_HW DEVICE
target 8 0/6/0/0.7 tgt CLAIMED DEVICE
The device file for the RAID160 SA controller in the example above is
/dev/ciss6.
Determining the RAID160 SA Firmware Version
The firmware version that is in the ROM on the RAID160 SA controller
can be determined by using either the sautil <device_file>
command (extensive output), or the sautil <device_file> -s
command (shortened output).