HP A7143A RAID160 SA Controller Support Guide

Installing the RAID160 SA Controller

RAID160 SA Controller Firmware

Chapter 4 83

Updating the RAID160 SA Firmware

The sautil command syntax for updating RAID160 SA controller

firmware is:

sautil <device_file> download_hba_fw <fw_image>

where:

<device_file> is the controller device file. The device file for the

RAID160 controller can be determined by running the ioscan -kfn

command as illustrated in “Determining the RAID160 SA Device

File” on page 76.

<fw_image> is the file path for the firmware version you want to

install on the RAID160 SA controller. The file path for the latest

RAID160 SA controller firmware file can be found in the

/opt/raidsa/bin/ directory in the SW depot download bundle. See

“Installing Software for the RAID160 SA Controller” on page 53, for

the complete file path.

When the sautil <device_file> download_hba_fw <fw_image>

command is issued, the firmware version that is currently installed will

be listed along with the firmware version you selected to replace it with.

You will have the opportunity to proceed with the download or cancel:

# sautil /dev/ciss6 download_hba_fw /opt/raidsa/bin/MAXWELL332.BIN

******************************************************************************

**** ****

**** S A U T I L S u p p o r t U t i l i t y ****

**** ****

**** for the HP A7143A RAID160 SA SCSI Adapter ****

**** ****

**** version A.01.01 ****

**** ****

******************************************************************************