HP A7143A RAID160 SA Controller Support Guide
Configuring the RAID160 SA Controller
saconfig Configuration CLI
Chapter 5 105
saconfig Configuration CLI
The saconfig command is used to:
• Configure Logical Drives
• Set the RAID level
• Set the stripe size on a RAID
• Set up on-line spare disk drives
• Delete logical drives
• Clear the configuration
You will need a superuser ID to run the saconfig command.
By issuing the saconfig command without any options, the saconfig
help screen with command options and syntax will be displayed:
# saconfig
No device file specified
******************************************************************************
**** ****
**** S A C O N F I G U t i l i t y ****
**** ****
**** for the HP A7143A RAID160 SA SCSI Adapter ****
**** ****
**** version A.01.03 ****
**** ****
**** (C) Copyright 2003-2005 Hewlett-Packard Development Company, L.P. ****
******************************************************************************
Usage:
To display configuration
saconfig /dev/cissX
To create logical drive
saconfig /dev/cissX -R <RAID level> [-S <Stripe size (KB)>]
-p <Channel:Target> [-p <Channel:Target> ... ]
[-s <Channel:Target>]