HP AD279A PCI 64-Port Serial Multiplexer Installation Guide, September 2006

HP PCI 64-Port Serial Multiplexer Adapter Installation

On-Line Addition and Replacement (OLAR) Operation on HP-UX 11i v1 Systems

Chapter 1

Step 1. Check whether the software is already installed on the system.

Step 2. Run the following command at the command prompt:

$ /usr/bin/rad -q

After you successfully run this command, you get the slot ID information to insert the adapter.

Step 3. Run the following command at the command prompt:

$ /usr/bin/rad -o slot_id

After you successfully run this command, you are prompted with a message stating that the power

on the slot is turned off.

Step 4. Insert the card in the chosen slot manually.

Step 5. Run the following command at the command prompt:

$ /usr/bin/rad -i slot_id

This command powers on the slot, recognizes the card, and creates device ﬁles.

Step 6. To check if the card is claimed and the device ﬁles are created, run the following command at the

command prompt:

$ ioscan -knfC tty

The following output is displayed:

Step 7. To list the device ﬁles created after installing the driver, run the following command at the

command prompt:

$ lssf /dev/tty*