HyperFabric Administrator's Guide (HP-UX 11i v2, includes Transparent Local Failover for HMP)

Configuring HyperFabric
Configuring HyperFabric with ServiceGuard
Chapter 494
Configuring HyperFabric with the ServiceGuard Resource
Monitor
You can configure the HyperFabric Resource Monitor with ServiceGuard
in either of these ways:
• Editing an ASCII file.
• Using the SAM GUI.
For more details, please see the manual Using EMS HA Monitors.
NOTE You should configure HyperFabric with ServiceGuard before running the
clic_start command or using SAM to start HyperFabric.
Configuring ServiceGuard with HyperFabric Using the ASCII
File
When using the ServiceGuard commands (for example, cmapplyconf)to
specify the use of the HyperFabric Resource Monitor, the section of the
package ASCII configuration file that has the keyword RESOURCE_NAME
must be uncommented and set to the following values:
RESOURCE_NAME /net/interfaces/clic/status
RESOURCE_POLLING_INTERVAL 10
RESOURCE_UP_VALUE =UP
Configuring ServiceGuard with HyperFabric Using SAM
You must perform the following steps when using SAM to configure the
HyperFabric Resource Monitor with ServiceGuard:
sam
Clusters
High Availability Clusters
Cluster Configuration (go through all the steps to create
a
cluster)
Package Configuration
Create/Add Package (if creating new packages)