HyperFabric Administrator's Guide (HP-UX 11i v2, includes Transparent Local Failover for HMP)

Configuring HyperFabric
Configuration Overview
Chapter 470
IMPORTANT In this file, clic_init and SAM add some HyperFabric-related lines
that end with the characters #clic. These lines are used by the
HyperFabric software — and are not comments — so do not remove
them from the file.
• The system /etc/rc.config.d/clic_global_conf file.
• The /etc/rarpd.conf (Reverse Address Resolution Protocol
[RARP]) support file. This file is used in the management of the
HyperFabric switches (if you are going to enable switch
management).
The clic_init command is described in “Using the clic_init Command”
on page 79. Using SAM to configure an adapter is described in “Using
SAM” on page 81.
After you have used the clic_init command or SAM, you can configure
HyperFabric with ServiceGuard, if necessary. For more information, see
“Configuring HyperFabric with ServiceGuard” on page 87.
You can configure card pairs for the Transparent Local Failover Feature
of HMP available with the B.11.23.01 release of HyperFabric. For more
information, see “Configuring HMP for Transparent Local Failover
Support” on page 96.