HyperFabric Administrator's Guide (HP-UX 11i v2, includes Transparent Local Failover for HMP)

Configuring HyperFabric
Information You Need
Chapter 474
Configuration Information Example
This example uses some “dummy” (that is, not valid) addresses to the
components in Figure 4-1. The dummy addresses are used only to show
the flow of the information provided as input to the clic_init command
and SAM. Do not try to use these addresses in your configuration.
To use clic_init to configure the Transparent Local Failover feature on
HMP, see the section, “Configuring HMP for Transparent Local Failover
Support - Using the clic_init command” on page 104.
Figure 4-1 Map for Configuration Information Example
node A
IP address: 193.0.0.20
IP address: 193.0.0.21
Ethernet MAC address:
Ethernet LAN
HF
Ethernet MAC address:
HF
IP address:
192.0.0.1
subnet mask:
255.255.255.0
IP address:
192.0.8.3
subnet mask:
255.255.255.0
node A
node A
IP address:
192.0.0.2
subnet mask:
255.255.255.0
IP address:
192.0.8.4
subnet mask:
255.255.255.0
node B
00:60:b0:d0:02:57
00:60:b0:d0:02:56
IP address: 193.0.0.10 IP address: 193.0.0.11
IP multicast address:
226.10.1.1
IP multicast address:
226.10.1.1
Switch ID: sw_clic0
switch 0
HF
switch 1
Switch ID: sw_clic1
adapter 0
HF
adapter 1
Adapter ID:
clic0
Adapter ID:
clic1
HF
adapter 0
HF
adapter 1
Adapter ID:
clic0
Adapter ID:
clic1
S
lan0 lan0
S