Updating Internal SAS Controller Firmware to Version 1.23.
© Copyright 2008 Hewlett-Packard Development Company, L.P. Legal Notices Hewlett-Packard makes no warranty of any kind with regard to this document, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. Hewlett-Packard shall not be held liable for errors contained herein or direct, indirect, special, incidental or consequential damages in connection with the furnishing, performance, or use of this material. Confidential computer software.
Updating HP 8 Internal Port SAS Host Bus Adapter And HP Multiport SAS Controller Firmware To Version 1.23.33 Or Later Updating the adapter firmware to version 1.23.33 or later might change the target ID of disk devices. This occurs on rx2660, rx3600, and rx6600 servers when an Integrated RAID volume is configured on the controller and you perform one of the following actions: • • Update the adapter firmware offline using sasflash.efi.
Updating The Adapter Firmware On rx6600 Servers To update the adapter firmware on rx6600 servers, follow these steps: 1. 2. Shut down and power off the system. Label the disks as follows: A B C D E F G H I J K L M N O P 3. 4. 5. 6. Partially remove each drive from its bay. Boot to EFI, and use sasflash.efi to upgrade the firmware. Shut down and power off the system. Move the drives to different bays, as follows: D C B A H G F E L K J I P O N M 7. Boot the system.