HP-UX 11i v3 Installation and Update Guide, September 2009 (Update 5 Release)

a. Navigate to the Software tab.
b. Select any optional software that you want loaded onto your system and
deselect any recommended (default-installed) software that you do not want.
Browse the list, marking your selections. Use the arrow keys to select a bundle
and the spacebar to change the option.
The bundles and associated product names are listed in Appendix C: “HP-UX
11i v3 software bundles contained in the OEs” (page 119). For information
about new and changed products and features, see the HP-UX 11i Version 3
Release Notes appropriate for the release you are cold-installing. The document
is available on the Instant Information DVD and on the web (http://
www.docs.hp.com/en/oshpux11iv3.html#Release%20Notes).
CAUTION:
HP recommends that you do not deselect recommended (default-installed)
software bundles or remove them from your system unless you know for
certain that the software contained in these bundles is not required for your
operating environment. Software may have unstated dependencies. Deselecting
software may prevent products with dependencies on the software you
deselected from functioning correctly.
Installing HP-UX 11i v3 installs a minimum set of default networking and
mass storage drivers that apply to the system. You may need to select or
specify other available networking and mass storage drivers to enable other
cards on your system.
7. Use the System tab to configure system parameters such as security levels, host
name, IP address, root password, and the time zone. You must set the appropriate
security setting for your system at this time. You can choose to set the other system
parameters now or at the first boot of your system, using set_parms(1M).
To set the appropriate security settings for your system, do the following.
IMPORTANT: You should become familiar with the security levels before you
set them. For more information about setting appropriate security levels, see
“Securing your system at install- and update-time” (page 37).
a. Navigate to the System tab and select Security Choices.
The four security levels appear. By default, Sec00Tools is selected.
b. Select the appropriate security setting for your system.
c. Select OK.
8. Use the File System tab to perform a variety of file system and disk-configuration
tasks: for example, resizing file systems, and adding and removing disks. You can
also reconfigure the volume structure and associated file system mount points.
52 Cold-installing HP-UX 11i v3 from local media