10GigEthr-02 (iexgbe) B.11.31.1303.01 Ethernet Driver Release Notes

3 Problems fixed in this release

The following defects were fixed in this release:

Table 3 HP-UX 11i v3 March 2013 fixes — 10GigEthr-02 B.11.31.1303.01

DescriptionSR number

iexgbe 1303 versions introduced issues due to missing firmware lock

The following symptoms might be seen because of this defect:

QXCR1001270195

• (QXCR1001268673) iexgbe driver continuously sends UP/DOWN notification events

to the WBEM provider.

The WBEM events seen by the user are of these types: DL_HP_EXT_LINK_DOWN_IND

and DL_HP_EXT_LINK_UP_IND.

• (QXCR1001267062) The nettl log becomes filled with link EPHY8073 link up

notification messages.

The following is an example of the messages seen:

<4006> 10GBase-SR in path 0/0/0/3/0/0/5

Link Event.

EPHY8073 link up or

<4006> 10GBase-SR in path 0/0/0/3/0/0/5

Link Event.

EPHY8726 link up

• (QXCR1001268375) Speed mismatch error frequently recorded in syslog.

The driver can present the following message in syslog during DLKM load/unload, boot,

or other control path operations:

internal_link_settings_status: 10G speed mismatch 0x300

• (QXCR1001268375) Ports for which the adapter reports the incorrect speed might

occasionally cause APA formation to fail during startup.

• iexgbe m45write and m45read message logged on the console.

(QXCR1001267051) During DLKM load/unload, the following message might be seen

on the console:

...m45write: Setting PHY address to write failed, phyreg 0xffe4, devad 0x7, val

0x1e0

...m45read: Setting PHY address to read failed 0x2227ffe4 0x1

(QXCR1001265402) During installation or deinstallation of the 10GigEthr-02 bundle, the

following message might be seen:

...m45read: Read of PHY register failed, addr 0x2227ffe4 init_done

status 0x2e270000

During system boot, the system might fail when bringing up TCP/IPQXCR1001265320

An error message such as "route add net : Network is Unreachable" is seen in /edt/rc.log.

Problem with nwmgr -s -A all --sa --fr cu -c commandQXCR1001267697

The command does not properly store the parameter settings in the

/etc/rc.config.d/hpiexgbeconf configuration file.

3 Problems fixed in this release 9